OUTLAW EAGLE MANUFACTURING

And, if you do plan to run continuously at 5000 RPM or more, aluminum impellers are no good. You need a steel impeller.

Air bubbles that go through the pump (cavitation) wear out the aluminum impe ...

I have a similar setup (20' tunnel)

I run 5100 RPMs with a B impeller. In order to get to 5400 RPMs you will have to go to a C.

The less boat in the water = the less drag = the more efficient the hull design.

The bigger the spray, the greater energy wasted not pushing the boat forward....

You can see photos of the Mexico Worlds at the Motonautica Mexico Facebook page.

https://www.facebook.com/media/set/?set=oa.10151973769221887&type=1

Indeed sad news. We received the notice at the races last week.

A gentleman, always showed a lot of appreciation for us mexicans racing in Canada.

Our thoughts go out to his family, specially P ...

Picture from day 3...

Congratulations to Gordon Humphrey and Chris Zapesocki. 2014 Overall World Champions, and first in Unlimited Class.

I will post pictures as we get a hold of them.

Other than "What kind of fuel are you using", I can't think of anything else, but probably the more knowledgeable guys at OE can.

Sounds like a computer doesn't want to lift up to 5200 RPM. You ar ...

This is the Schedule for the 2014 World Jet Boat Marathon, to be held in Mexico. Save the date for May 3rd thru 11th, 2014.

Pump up the stereo volume...

As you know, Mexico is hosting the 2014 UIM World River Marathon.

We are planning to host the race at the spectacular Usumacinta river, in south east Mexico.

Planning is under way, and we have t ...

1. The bill at the engine shop was $2600. A lot better than $4500. This incident happened on his second run with a brand new ZZ4. I would have done the same.

I guess I hadn't got it right, then... ...

I was saving my comments for future discussion, but I will throw something in for the controversy:

If we go back to the 2011 inspection:
The cylinder head was CRACKED. The cost of repairing was a ...

My advise, taken from direct experience in my trip to that area:

Please note that after High Level, Alberta, the next fuel facility is about 250 Km / 170 miles. Stop there for fuel. There's a rea ...

Long or short shaft??? The answer depends on the actual transom height.

Since the kicker motor will be placed on an adapting plate, that could probably be adjusted to receive either.

The impor ...