OUTLAW EAGLE MANUFACTURING Forum Index OUTLAW EAGLE MANUFACTURING
ALUMINUM BOAT FORUM
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

AT SD-309 seal replacement

 
Post new topic   Reply to topic    OUTLAW EAGLE MANUFACTURING Forum Index -> OE GENERAL FORUM
View previous topic :: View next topic  
Author Message
Scottie



Joined: 06 Feb 2007
Posts: 16
Location: Yellowknife NT
PostPosted: Sun May 15, 2016 1:30 pm    Post subject: AT SD-309 seal replacement Reply with quote
I have an SD309 that leaks water out the forward weep hole when static and at cruise RPM. I'm wondering what the easiest route is for replacement. Motor and pump removed or can a guy work with just the motor removed ? Boat is a 2004 E6 with a kodiak 350. Bell housing that mounts to the front of the pump.

Thanks in advance.
Scott
Back to top
View user's profile Send private message
TOP DAWG



Joined: 15 Jun 2005
Posts: 574
Location: Peace River Alberta anada
PostPosted: Mon May 16, 2016 9:04 am    Post subject: Reply with quote
Your engine or pump has to come out but not both. Was easier to pull the engine and leave the pump in the boat.
_________________
Bulls Eye Enterprises Inc.
Shop:780-833-1462
Cell : 780-618-7537

www.bullseyeenterprises.ca

follow us on instagram @bulleyeenterprises

Like us on Facebook

https://www.facebook.com/bullseyeenterprisespeaceriver?ref=hl
Back to top
View user's profile Send private message Send e-mail Visit poster's website
ve6ddd



Joined: 04 Sep 2015
Posts: 2
Location: Rocky Mtn House,AB
PostPosted: Wed May 18, 2016 10:14 pm    Post subject: Reply with quote
Just did mine 2 weeks ago. Four bolts and the wiring harness disconnected and lifted the motor up and over enough to change the seal. Used an engine lift and didn't remove the motor completely out of the hull. Took about 5 hours with no help....other then the wife as a safety number.
Back to top
View user's profile Send private message
ALEX



Joined: 02 Aug 2005
Posts: 176
Location: red deer
PostPosted: Wed May 18, 2016 11:28 pm    Post subject: Reply with quote
You can sometimes get away with replacing just the carbon back part of the seal;remove impeller;pull cotter pin;pull spring and carbon face of seal out;check ceramic face still on shaft for damage;if it is ok slide new carbon on shaft (use antifreeze to lube where it slides on shaft) and put back together.Cross fingers and test run.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    OUTLAW EAGLE MANUFACTURING Forum Index -> OE GENERAL FORUM All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group :: Spelling by SpellingCow.